Hi,
I opened a case at Yuneec support, but since I got no answer yet, I refer to your collective experience to see if anybody has come across a similar issue. Thanks in advance for your help.
Here it goes :
My Breeze 4K went in soft water a week ago after "deciding on its own" to drop like a rock from 10 feet height even if the battery was over 50% and everything was working normaly.
After drying it carefully for 3 days, I tried to power it up again. The LED and sound signal seems to work fine but I get no wifi. When I plug it to my computer through USB, the drive is not shown.
However, a device "A9S" is detected by Windows. My guess is that the "computer section" of the breeze is not booting-up at all, maybe a filesystem problem after its submarine experience.
My question for you is to know if there is a utility to flash a new firmware on this A9S device through USB from a Windows 10 computer ? If so, where can I get the firmware image for it ?
Thanks,
JL
I opened a case at Yuneec support, but since I got no answer yet, I refer to your collective experience to see if anybody has come across a similar issue. Thanks in advance for your help.
Here it goes :
My Breeze 4K went in soft water a week ago after "deciding on its own" to drop like a rock from 10 feet height even if the battery was over 50% and everything was working normaly.
After drying it carefully for 3 days, I tried to power it up again. The LED and sound signal seems to work fine but I get no wifi. When I plug it to my computer through USB, the drive is not shown.
However, a device "A9S" is detected by Windows. My guess is that the "computer section" of the breeze is not booting-up at all, maybe a filesystem problem after its submarine experience.
My question for you is to know if there is a utility to flash a new firmware on this A9S device through USB from a Windows 10 computer ? If so, where can I get the firmware image for it ?
Thanks,
JL