Do At Your Own Risk
now here how I was taught how to bind the c23 to the h520. (h plus owners with latest c23 firmware and do this please inform me if the digital zoom works my c23 is on older firmware and zoom on it not enabled.)
step one h520 no props on place battery in copter
step 2 attach c23 camera to h520.
step 3 power on h520 wait for the c23 led to go to blinking green.
step 4 power on st16s
step 5 when st16s is fully powered on and data pilot loaded up back out of data pilot into the android interface.
step6 go to setting in the android go to wifi then open wifi.
step 7 on the wifi list look for c23 camera it should be on the list select it and enter the password for it default is 1234567890.
step 8 go back to datapilot if done correctly you will get video feed
step 9 check the controller icon should be normal not flashing red. the data pilot will say app on wifi connection but camera settings should list it as e90.
step 10 check to make sure that the gimbal controls work fully with the camera if all is good the camera will fully respond.
now when you change cameras or switch wifi connections on the st16s or do firmware updates with a h520 official supported camera you have to do steps 1 to 10 again.
Note This is yet to be tested with the data pilot mission software.
Also you will not be able to do firmware updates from yuneec updates and the sd card slot of the c23 camera.
(important note)I saying the sd card slot not avalible for firmware updates. for now and do not attempt for now, because I am waiting for a data pilot software update for flight controller update to confirm for myself that it can be done without issues before saying it can be done.
However if you do not change anything the c23 should pick right back up and be usable. Did 3 st16s battery changes and 8 flight battery changes and the c23 came back up fully functional every single time.
hold on to your hats I may have another camera hack in the works to bring another one to the h520 family okay that semi worked I going to have to open the cgo3+ and change a few boards for full conversion.