Accessory holder for st16. Looking for ideas...

[Vaklin]

The next 3D print will be an accessory holder for ST16. They should be from one part, tied to the ST16, and different replacement parts, which will be a free choice. $Hawks holed is a good candidate for development. Can someone post a few detailed photos from this one?

 

[P Howard]

The next 3D print will be an accessory holder for ST16. They should be from one part, tied to the ST16, and different replacement parts, which will be a free choice. $Hawks holed is a good candidate for development. Can someone post a few detailed photos from this one?

View attachment 25520

Are you looking for more pictures of the antenna you posted. Sorry, I guess I am a bit confused.

 

[Vaklin]

Not the antenna itself but the holder to the ST16. A few shots from different sides and angles can give me more detailed information how on this is shaped. For example, how the antenna is locked to the controller and so on?

If you have the same antenna, just make some pictures on the backside from a near distance. If I want something more detailed, I'll point it.

Regards!

 

[P Howard]

First batch

 

[P Howard]

Rest of them. Need something else, let me know. I hope this is helpful.

 

[Vaklin]

Please the bracket, detached from the ST. This is the most important part for me.

Thank you!

 

[P Howard]

I shall wait until tell me you don’t need any more before I reassemble the antenna.

 

[Vaklin]

Caught it. The bracket is from two parts. Tomorrow I'll look the pictures on a big screen.

From what material they made? Metal or plastic?

 

[P Howard]

Metal

 

[Vaklin]

Thank you. All is clear. You can assemble the antenna.