Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

CGO3+ wont power up

Aki

Joined
Jul 29, 2016
Messages
1
Reaction score
0
Age
34
I crashed my H and some wires and base are broken. So, I just got new replacement of my camera. However, it does not power up.
H turns on fine, but CGO3+ does not move an inch...
The previous broken camera was connected fine with the drone so I hope i just got a bad replacement camera.

Is there any way to check if the problem is on drone or camera? thanks.
 
Do you have video? If so, try re-binding the CGO3+ to the ST16 controller.
 
Check the contact points on the drone connection plate. I had the same problem - turns out that somehow one of the contact points became recessed. I moved it back into the correct position and all was fine again.
 
I have this same issue.

I assumed my CGO3+ was damaged during a crash, I purchased a new one while I try to find someplace to fix the old one.

Turns out the new camera doesn't power up either. I even replaced the contact board with a new one that was included with the new CGO3+.

It doesn't turn on, so its not possible to bind, there's just no power.
 
Jules,
Probably best to give Yuneec a call and have them help sort it out.
It sounds like you have done all the right things so far.
 

New Posts

Members online

No members online now.

Forum statistics

Threads
20,955
Messages
241,590
Members
27,284
Latest member
csandoval