CGO3+ wont power up

Aki · Jul 29, 2016

I crashed my H and some wires and base are broken. So, I just got new replacement of my camera. However, it does not power up.
H turns on fine, but CGO3+ does not move an inch...
The previous broken camera was connected fine with the drone so I hope i just got a bad replacement camera.

Is there any way to check if the problem is on drone or camera? thanks.

BFD400 · Jul 29, 2016

Do you have video? If so, try re-binding the CGO3+ to the ST16 controller.

Yuneec_Usa · Jul 29, 2016

Hello Aki,

Did you rebind the new camera to ST16? Videos below may help you.

SkyEye · Jul 30, 2016

Check the contact points on the drone connection plate. I had the same problem - turns out that somehow one of the contact points became recessed. I moved it back into the correct position and all was fine again.

JulesTEO · Oct 17, 2016

I have this same issue.

I assumed my CGO3+ was damaged during a crash, I purchased a new one while I try to find someplace to fix the old one.

Turns out the new camera doesn't power up either. I even replaced the contact board with a new one that was included with the new CGO3+.

It doesn't turn on, so its not possible to bind, there's just no power.

BobW55 · Oct 18, 2016

Jules,
Probably best to give Yuneec a call and have them help sort it out.
It sounds like you have done all the right things so far.

JulesTEO · Oct 21, 2016

BobW55 said:
Jules,
Probably best to give Yuneec a call and have them help sort it out.
It sounds like you have done all the right things so far.

Thanks Bob, turns out the main power board was damaged, so I replaced it and things are working fine now

I just posted a thread here: Brought my CGO3+ back from the dead!

Greetings!