And another question!!! Tell me how to make the function of the POI, I try to, but Phantom H can not it. Phantom, flying a little bit aside privately and stops:.Please describe point by point.!!!!!!!!
this is how I do POI
First make sure you are in advanced mode
A. Select 'system settings' on bottom of remote
B. Select 'other settings'
C. Turn on advanced mode and back out to home screen
Start up and get into the sky my switch possitions are as follows
Both left switches are in top position
My right switches OBS is all the way up (off)
and far right set to center (angle mode)
Fly directly over an object like a house and point your camera straight down to find the center of where u want to circle
I then switch to smart mode (right switch in up position)
Next select task on lower right of remote and select POI press skip instructions and select center (this centers your H where it's positioned).
Next fly straight out like 100' and make sure your high enough to prevent any collisions with trees/power lines.
Press start on the remote and then slide to start to confirm
Finallay push your right joystick left or right to start it circling. Once it starts moving select 'watch me' on the lower right side of remote (above the task camera selection) and the unit will center it's camera on the center of point of interest. Adjust your camera up so it sees the object you are circling. Then simply hit record or snap photos
Unit will circle until you select 'exit' or battery goes low. Also note if you start your circling and want the unit to move slower simply press lighter on the right joystick (press halfway left or right) and it will circle slower
Hope this helps
