Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

I need help with gyroscope, a New Member from Kentucky.

Joined
Dec 19, 2024
Messages
2
Reaction score
0
Age
62
Here is a shout-out from Kentucky. I own a Typhoon H. I Did not use it much, maybe three times. The problem is that the gyroscope shakes and jitters. I need help fixing it to get back up in the air. Any help is greatly appreciated.


I may be missing two pins. CG03+ Would this cause the jitters?


1734635700534.png
1734635852797.png
 
Last edited:
Hi Joshua, welcome from Italy.
What do you mean for "gyroscope"? The camera gimbal?
Have you already tried to perform a calibration?
Hi Pier, yes, I do the calibration, but the camera shakes, like gittering, when on.
 
I need help fixing it to get back up in the air. Any help is greatly appreciated.
If it has been in storage for a long while it may be suffering from degradation of either the pitch or roll magnets. It would be unlikely the degradation is enough to be visible if the gimbal can initialize at all. You may be able to tell a difference by touching each magnet with a screwdriver to see if either is noticeably weaker than the other.
The image below shows the progression from weak (but normal appearance), to severe degradation.
Examples.jpg

I may be missing two pins. CG03+ Would this cause the jitters?
No. That is normal. The camera came with only two pins. Left front and right rear.
 

Members online

Forum statistics

Threads
21,327
Messages
245,653
Members
28,262
Latest member
kybelvody