Hi all,
I crashed and totalled my first Q500 4K drone the other day, so went and bought a replacement. A new Q500 4K with a new ST10+ control.
I decided to re-use the old ST10+ (as it was as new). So went through the procedures to 'Bind' the bird and the CGO3 to the ST10+. This is where my problems all began......
The ST10+ binded with the Q500 without a hitch, but the CGO3 not so. When and if the CGO3 decided to bind, the display on the ST10+ would flash on and off. In addition to this, the ST10+ display would jump into the 'Settings' menu.
I have since hooked up the new Q500 to the GUI to install the latest firmware. Done.
I have also tried and tried to update the firmware on the ST10+, but i am sad to say i cannot figure out as to why the controller fails to identify a SD card installed (installed into the battery compartment). After all, its not rocket science, given how many youtube tutorials are out there......
Anyway, before folks advise that i use the New ST10+, i can say i did, and have noticed that there is ALOT of lag with the image.
Any advice would be greatly appreciated.
Pete
I crashed and totalled my first Q500 4K drone the other day, so went and bought a replacement. A new Q500 4K with a new ST10+ control.
I decided to re-use the old ST10+ (as it was as new). So went through the procedures to 'Bind' the bird and the CGO3 to the ST10+. This is where my problems all began......
The ST10+ binded with the Q500 without a hitch, but the CGO3 not so. When and if the CGO3 decided to bind, the display on the ST10+ would flash on and off. In addition to this, the ST10+ display would jump into the 'Settings' menu.
I have since hooked up the new Q500 to the GUI to install the latest firmware. Done.
I have also tried and tried to update the firmware on the ST10+, but i am sad to say i cannot figure out as to why the controller fails to identify a SD card installed (installed into the battery compartment). After all, its not rocket science, given how many youtube tutorials are out there......
Anyway, before folks advise that i use the New ST10+, i can say i did, and have noticed that there is ALOT of lag with the image.
Any advice would be greatly appreciated.
Pete