So I had a light not working at all on one of the new units.
1) take cover off and make sure led is connected. V check
2) remove light and move to other side and test. V check (worked great)
3) look in ARN joint to see if the cable is loose. V check (the led cable is now bound with the motor cable , do couldn't see anything other than the braided wire cover)
4) remove to cover and make sure it was connected. V check ( it was not connected)
5) attach disconnected cable and test light. V check ( was a rear light and should be flashing light blue , one was the faulty one was flashing red)
6) click arm into position and noticed cable feel out.... Pushed back in.... Falls out easily. Look into plug one pin is bent over and not making contact. Try to carefully straighten pin. Pin snaps. Heart sinks. Notice pin connector is same as in old broken camera. Desolder connector from camera and from ESC board. Re solder to ESC board and connect.
7) test light and connector. V check (working as it should)
8) contact Yuneec and request an ESC board to replace. Confirm board to be sent with all my other spare parts when I order them along with the CGO-ET Cameras. V check.
9) put it back together. V check
10) tell forum and upload some pictures. V check
As you can see Yuneec has uped their game with the electronics. Nice little things like the holder clips for the motor wires. The 8gb card for the mission uploads. The antennas not inside a silly bit of heat shield. The overall quality of the ESC board when compared to a H480.
Haydn
www.mountainview.enterprises
1) take cover off and make sure led is connected. V check
2) remove light and move to other side and test. V check (worked great)
3) look in ARN joint to see if the cable is loose. V check (the led cable is now bound with the motor cable , do couldn't see anything other than the braided wire cover)
4) remove to cover and make sure it was connected. V check ( it was not connected)
5) attach disconnected cable and test light. V check ( was a rear light and should be flashing light blue , one was the faulty one was flashing red)
6) click arm into position and noticed cable feel out.... Pushed back in.... Falls out easily. Look into plug one pin is bent over and not making contact. Try to carefully straighten pin. Pin snaps. Heart sinks. Notice pin connector is same as in old broken camera. Desolder connector from camera and from ESC board. Re solder to ESC board and connect.
7) test light and connector. V check (working as it should)
8) contact Yuneec and request an ESC board to replace. Confirm board to be sent with all my other spare parts when I order them along with the CGO-ET Cameras. V check.
9) put it back together. V check
10) tell forum and upload some pictures. V check
As you can see Yuneec has uped their game with the electronics. Nice little things like the holder clips for the motor wires. The 8gb card for the mission uploads. The antennas not inside a silly bit of heat shield. The overall quality of the ESC board when compared to a H480.
Haydn
www.mountainview.enterprises