Left control stick during decent......

AH-1G · Feb 18, 2021

While descending whether in angle mode or sport, it's extremely slow, I mean very slow even in rabbit sport mode?
Is there a video so I can check and adjust my stick?

h-elsner · Feb 18, 2021

What is your vertical speed up and down in flight logs. Has the H Plus HW monitor, I think yes. There can you check the sticks. Has it output monitor? I don't know, but the output values are recorded in flight logs (flight2log) also.

br HE

WTFDproject · Feb 18, 2021

AH-1G said:
While descending whether in angle mode or sport, it's extremely slow, I mean very slow even in rabbit sport mode?
Is there a video so I can check and adjust my stick?

What does J1 look like in "RC Monitor? (See PDF Below)
If it is not working, clean the pots as described in this video.

AH-1G · Feb 18, 2021

J1 65% ascend 50% descend, angle or sport mode.
I cleaned with CRC QD Electronic Cleaner no changes

AH-1G · Feb 18, 2021

h-elsner said:
What is your vertical speed up and down in flight logs. Has the H Plus HW monitor, I think yes. There can you check the sticks. Has it output monitor? I don't know, but the output values are recorded in flight logs (flight2log) also.

br HE

The ST16s is not the same as the ST16 for locating different control settings.
Where do I go to re-calibrate my sticks controls for the H+?

AH-1G · Feb 18, 2021

WTFDproject said:
What does J1 look like in "RC Monitor? (See PDF Below)
If it is not working, clean the pots as described in this video.

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

thanks, did what you sent. Now to find how to recalibrate the control sticks

Tazmanic · Feb 20, 2021

AH-1G said:
While descending whether in angle mode or sport, it's extremely slow, I mean very slow even in rabbit sport mode?
Is there a video so I can check and adjust my stick?

Hi there,

Had same problem on the standard ST 16 found the fault to be the adjustment spring, it had stretched, so took 1 out of my ST 10 and back to normal.

Hope this helps ?.

AH-1G · Feb 20, 2021

Tazmanic said:
Hi there,

Had same problem on the standard ST 16 found the fault to be the adjustment spring, it had stretched, so took 1 out of my ST 10 and back to normal.

Hope this helps ?.

Thank you, I will be dismantling the controler so I can clean the sticks from the inside, @Ty Pilots suggestions.

DoomMeister · Feb 20, 2021

See Attachment 40 in this document https://yuneecpilots.com/attachments/wtfdproject-rev75-pdf.24940/

Tazmanic · Feb 20, 2021

AH-1G said:
Thank you, I will be dismantling the controler so I can clean the sticks from the inside, @Ty Pilots suggestions.

Hi, no problem. ?

h-elsner · Feb 21, 2021

I have good expriences with soldering the wires directly to the pots. One connector is enought to disassemble the stick gimbals. To connectors is one too much. Two connectors doubles the probability of faults.

br HE