Little late, but......

[cabinfourus]

Hey guys, I just wanted to share some more information about me. This is the link to my Facebook page.

John Johnson

John Johnson is on Facebook. Join Facebook to connect with John Johnson and others you may know. Facebook gives people the power to share and makes the world more open and connected.

www.facebook.com

If anyone here sends me a friend request, make sure to let me know you are from the forums and I will accept it.

 

[h-elsner]

I'm not on Facebook
However, I like what you doing, what you are.

Btw, nice car!

 

[cabinfourus]

I'm not on Facebook
However, I like what you doing, what you are.

Btw, nice car!

Thanks. Which car are you talking about? The GTO, Volvo, or Lincoln? The GTO was my first car, and I still have it.
I have a question for you. Can you provide a wiring diagram of your setup for the gimbals calibrations? I noticed you use a battery in your setup, and may try to do this with mine.
I love the wooden stand you made!!

 

[h-elsner]

My setup is very chaotic but flexible to use. I can use the H480 battery or a power supply. The wiring is made to add a logic analyzer to record the communication between drone and camera or drone and calibration tool. This setup is here:

GitHub - h-elsner/H480_UART_reading: Reverse engineering serial connections at Yuneec Typhoon H

Reverse engineering serial connections at Yuneec Typhoon H - h-elsner/H480_UART_reading

github.com

To calibrate the camera you need only the connection between a serial-USB converter and Rx / Tx of the camera as described in the tool description. It is a good idea is to add a switch in +Vcc wire to power cycle the camera.

Here is a wiring example with YUNA100:

 

[cabinfourus]

My setup is very chaotic but flexible to use. I can use the H480 battery or a power supply. The wiring is made to add a logic analyzer to record the communication between drone and camera or drone and calibration tool. This setup is here:

GitHub - h-elsner/H480_UART_reading: Reverse engineering serial connections at Yuneec Typhoon H

Reverse engineering serial connections at Yuneec Typhoon H - h-elsner/H480_UART_reading

github.com

To calibrate the camera you need only the connection between a serial-USB converter and Rx / Tx of the camera as described in the tool description. It is a good idea is to add a switch in +Vcc wire to power cycle the camera.

Here is a wiring example with YUNA100:
View attachment 32208

Okay, I gotcha. Is that what you use your battery for?

 

[h-elsner]

Battery or power supply. If I'm too lazy to grab the lab power supply and wire it I take simply the battery. I have an old one that is no more usable to fly but good for tests on the ground.