Must have tools
- Thread starter johnnyb57
- Start date
There will never be an end to "I need a ..." for those of us that like to tinker, but here is a good start:
Set of magnetic hex drivers that include 1.5mm, 2.0mm and 2.5mm.
Set of magnetic screwdrivers. (Lots of “electronics” sets out there)
Set of non-magnetic, anti-static tweezers.
Small needle nosed plyers.
Soldering iron and accessories.
Set of magnetic hex drivers that include 1.5mm, 2.0mm and 2.5mm.
Set of magnetic screwdrivers. (Lots of “electronics” sets out there)
Set of non-magnetic, anti-static tweezers.
Small needle nosed plyers.
Soldering iron and accessories.
This is the driver set that I use. It is superior quality.
RC Screw Driver Kit with 4 Hex Screwdrivers
or
https://smile.amazon.com/NEEWER®-Titanium-Nitride-Driver-Wrench/dp/B00CP2GGBI/ref=sr_1_7?keywords=4+hex+screwdriver&qid=1573327480&sr=8-7
RC Screw Driver Kit with 4 Hex Screwdrivers
or
https://smile.amazon.com/NEEWER®-Titanium-Nitride-Driver-Wrench/dp/B00CP2GGBI/ref=sr_1_7?keywords=4+hex+screwdriver&qid=1573327480&sr=8-7
As far as small needle nose pliers, I have hemostats which should suffice
Maybe a 3lb. sledge, when the others aren't workin ?
PatR
Premium Pilot
Never, ever use magnetic tools around computer chips and electronics. They make removing and installing screws easy but make replacing components ruined through magnetization expensive.
What about the Lens removal tool for under the motor, and arm, can be very difficult to remove without.
Last edited:
- Joined
- Nov 6, 2018
- Messages
- 1,103
- Reaction score
- 1,013
- Age
- 59
- Location
- DFW Metroplex
- Website
- orbisdroneservices.com
I can vouch for duct tape, the aluminum type not the cloth type.
