Hi everyone , new to the forums
A really nice helpful guy on facebook recommended posting here .
I have recently bought a typhoon h with cg03+ camera and st16 controller , it turns out it had been crashed long story short the wires were ripped from the camera and the K fuse has blown on the mainboard..
My fault and problem is i have no pan or tilt.
I have wired the cameras power externally , and connected the green tx wire and white pwn wires to the slide mount connectors on the drone.
i have checked all the continuity of the wires and all is good .
the light on the gimbal board is solid green and the led on the camera flashes green
it binds to the controller as i can change iso and view video etc.
I get video feed and everything else with the drone seems to work fine , when i try to calibrate gimbal nothing happens the camera doesn't move
The camera does however if i turn it by hand it re centres..
Last thing when i power the camera on the gimbal moves left to 45deg and then back to right 45deg and back and forth like this . unless holding the motor then it stays still facing forward..
Sorry for the long post , i wanted to cover all my bases to give you guys a heads up to what i've done and checked. Thanks Si
A really nice helpful guy on facebook recommended posting here .
I have recently bought a typhoon h with cg03+ camera and st16 controller , it turns out it had been crashed long story short the wires were ripped from the camera and the K fuse has blown on the mainboard..
My fault and problem is i have no pan or tilt.
I have wired the cameras power externally , and connected the green tx wire and white pwn wires to the slide mount connectors on the drone.
i have checked all the continuity of the wires and all is good .
the light on the gimbal board is solid green and the led on the camera flashes green
it binds to the controller as i can change iso and view video etc.
I get video feed and everything else with the drone seems to work fine , when i try to calibrate gimbal nothing happens the camera doesn't move
The camera does however if i turn it by hand it re centres..
Last thing when i power the camera on the gimbal moves left to 45deg and then back to right 45deg and back and forth like this . unless holding the motor then it stays still facing forward..
Sorry for the long post , i wanted to cover all my bases to give you guys a heads up to what i've done and checked. Thanks Si