No video after upgrade

[Idark]

Hi
Upgraded to 1.1.03.20190312 today and everything looked fine. but no contact with the camera.
It binds to the camera but that's all.
Gimbal works

 

[oliver]

Hi, what is your build ? 822/829 ?
if that's it, I had the same problem, go down to 784

 

[TurboDad81]

Try going into the camera setting and switch it to AUTO, or adjust the manual settings. When I upgraded once before, it was in manual mode and adjusted my camera settings to the point that the screen was black.

 

[Idark]

Try going into the camera setting and switch it to AUTO, or adjust the manual settings. When I upgraded once before, it was in manual mode and adjusted my camera settings to the point that the screen was black.

The screen is not black. The wallpaper images/slideshow is running. Can't change camera settings since i have no contact with camera. All camera info ISO/Shutter/WB etc has N/A values

 

[Idark]

I see there are C and E versions of the c23 files in the yuneec.ota folder. Can this mess up things?
And on the sd card in the camera there are autopilot.yuneec.updated and gimbal.yuneec.updated but not a c23 file. Is that correct?

 

[RPR]

Unbind you camera.
Copy the C23 file according to your country C23_C for China/US. C23_E for U.K.

* Change the extension ‘.yuneec’ to ‘.zip’ unpack.
* Copy the camera.bin to a formatted micro sd card.
* Load as card to C23.
* Cycle. C23 camera will blink red, when processing and green when finished.
*Check sd card.
The bin file should automatically been deleted.
*Cycle ST16s and C23
*Rebind C23

 

[Idark]

Got the 748 version from Yuneec. Now I have video ?

 

[RPR]

Congrats