Have rebind model but can not connect to Camera.
Gimbal is possible to move but have white led on Camera not green.
Have not found any information white led on Camera .
And i have no wi-fi connect , not possible reload firmware.
Further information, i had problem with Elevator stick travel ,stick Max travel only
20% all other channel 100% . Was only possible to fly wery low speed forward or
back. Angle mode , rabbit mode and obstacle avoidance off.
Did factory reset tablet and Elevator travel same 20%.
After moving Elevator stick many time's i suddenly got 100 % travel and it is
Now ok but i have to rebind Typhoon and It was possible but not possible to rebind to
Camera.
Do i need to load new FW , ST16 after factory reset of ST16 ?
White led on Camera ?
Gimbal is possible to move but have white led on Camera not green.
Have not found any information white led on Camera .
And i have no wi-fi connect , not possible reload firmware.
Further information, i had problem with Elevator stick travel ,stick Max travel only
20% all other channel 100% . Was only possible to fly wery low speed forward or
back. Angle mode , rabbit mode and obstacle avoidance off.
Did factory reset tablet and Elevator travel same 20%.
After moving Elevator stick many time's i suddenly got 100 % travel and it is
Now ok but i have to rebind Typhoon and It was possible but not possible to rebind to
Camera.
Do i need to load new FW , ST16 after factory reset of ST16 ?
White led on Camera ?
Last edited:
