So I've completely deleted all remnants of St 16 and Typhoon H firmware and reinstalled firmware on St16 and Typhoon H. I've been calibrating the ST 16 and in the first step which shows J1, J2, J3, J4, K1, K2, K3 all of them turned green except for J2. When I proceed to next level of calibration for all ST controls J2 works fine and I receive the "Passed" notification. When I test the J2 in the Hardware monitor it also works fine...got any ideas what may be the problem?
I've ordered a new 3 antenna ST 16 from a nearby hobby shop for $195 (I think they must be dropping the Yuneec line) as all there stuff was pretty cheap for Yuneec parts and accessories.
Just curious if anyone has any ideas why J2 stays red while all the others in the test turned green. I did go into Channel settings and did a reset there for J2 but that did not solve the problem.
I've ordered a new 3 antenna ST 16 from a nearby hobby shop for $195 (I think they must be dropping the Yuneec line) as all there stuff was pretty cheap for Yuneec parts and accessories.
Just curious if anyone has any ideas why J2 stays red while all the others in the test turned green. I did go into Channel settings and did a reset there for J2 but that did not solve the problem.