Typhoon H arm latch replacement (metal part in main body)

[w4yn]

I need to replace 2 of the aluminum catches that snap into the arm metal retainer.
Is there a video on how much of drone I need to remove to get to the retaining screws?
Tim

 

[Enrico Jorysch]

You don't need to disassemble any parts of the drone.

Using the small screwdriver, remove the very small Phillips-head screw, take out the spring mount, and replace it with a new one.

This takes about 1 minute per arm.

 

[WTFDproject]

You do need to remove the top shell. Remove the six 1.5mm hex screws from around the edge of the shell. Unsnap the latches on each side of each motor opening. Disconnect the GPS connector.

 

[w4yn]

I had to remove the bottom cover and the Landing Gear servos
It was the cast clip that broke not the stamped metal piece in arm.
Tim

 

[Steve Carr]

You may find some of these videos helpful for H repairs:

Yuneec Typhoon Repair Tutorials

Share your videos with friends, family, and the world

youtube.com

 

[DBM]

This site is such an awesome resource for me to learn how to fix and then fly my old school H480. Still waiting on a few parts and then I will be posting many questions. Thank you to the many experts that keep this data stream going.