Hello folks, hope all is well with you. I have spent some time viewing the site and others for a resolution to my problem. but to no resolve. I see it has been touched on but have yet to find a solution that works.
TH had been giving issues and decided to update the TX and RX. I have the tx on b30 and have a connection to the drone and camera via 5.8 and 2.4. I am trying to update the firmware to the newest version from yuneecs site.
This has not been successful when I attach the USB cable it, it auto-selects com3 and begins the update till about 1% and stops dead. the update icon button goes black from a grey out display. I will then select the update button and it begins the update and stops again at the same point. I have also tried the wireless version using the TX and it failed also. It would begin to update and then stopped at one point saying something about Http.
Points:
Formatted sd card inserted into the camera and connected USB, began autorun and stopped, using GUI.
Tried using the TX wifi setup and failed also.
Have downloaded the files from the us and uk sites and tried both. FAILED.
Each time I then need to revert back to the 1.28 fw which installs without issue and drone comes back to life.
Any advice would be greatly appreciated and if I have touched on a topic that has been dealt with, I apologies in advance and hope you can point me in the right direction.
kind Regards
Skydive
TH had been giving issues and decided to update the TX and RX. I have the tx on b30 and have a connection to the drone and camera via 5.8 and 2.4. I am trying to update the firmware to the newest version from yuneecs site.
This has not been successful when I attach the USB cable it, it auto-selects com3 and begins the update till about 1% and stops dead. the update icon button goes black from a grey out display. I will then select the update button and it begins the update and stops again at the same point. I have also tried the wireless version using the TX and it failed also. It would begin to update and then stopped at one point saying something about Http.
Points:
Formatted sd card inserted into the camera and connected USB, began autorun and stopped, using GUI.
Tried using the TX wifi setup and failed also.
Have downloaded the files from the us and uk sites and tried both. FAILED.
Each time I then need to revert back to the 1.28 fw which installs without issue and drone comes back to life.
Any advice would be greatly appreciated and if I have touched on a topic that has been dealt with, I apologies in advance and hope you can point me in the right direction.
kind Regards
Skydive