Hey everyone out there. I went out of town for a job that my company was contracted to shoot. I get there setup, and get ready to launch, the compass said it wasn't getting a strong heading/signal, and that I would have to to fly manually(not a problem). So I get in the air, video to the ST16 is fine, start recording, video is fine for a bit and then it goes in and out, Like it freezes and it takes a bit for the transmission to get to the screen on the ST16. Now I'm shooting a location with lots of metal, metal buildings(iron) loads of drill pipe and iron all over the place, this is a drilling rig that I'm trying to shoot. Not to mention they have wifi broadcasting and it it's in this small area that I'm trying to shoot. I get home today and test it out. everything is fine. Would anyone know what I can do to prevent this from happening again, as I have other jobs to do from that company and I'm going back to reshoot from Saturday. Any suggestions and tips are appreciated.