I recently acquired a Typhoon H and, I am confused. The firmware is updated on both the ST16, the aircraft, and the camera, and I took it out last night to do a compass calibration and (hopefully) fly it for the first time. However, when the compass calibration started, it did not match the LED configurations in the manual, and I am unsure how to proceed with it.
When I begin the calibration, it starts as usual (main LED blinking red/green, all motor LEDs blinking). The nose of the aircraft is facing north. Then, instead of the left and right motors lighting up green and red, I get two motors (that are separated by 120 degrees, not 180) lighting up. I'll rotate the aircraft between them about 1.5 times, and, around that point in time (usually while the aircraft is upside down), a new set of LEDs will come on -- again usually separated by 120 degrees. I'll finish flipping the aircraft over, turn it to match the new LEDs, and flip it again. About 1.5 turns later (again, the aircraft is upside down), the LEDs will change again -- and so on. The third time or so they are usually LEDs separated by 180 degrees, but, at the end of the day, the calibration fails and I have no clue what's happening.
Any ideas? I'm quite lost here and any help is appreciated.
When I begin the calibration, it starts as usual (main LED blinking red/green, all motor LEDs blinking). The nose of the aircraft is facing north. Then, instead of the left and right motors lighting up green and red, I get two motors (that are separated by 120 degrees, not 180) lighting up. I'll rotate the aircraft between them about 1.5 times, and, around that point in time (usually while the aircraft is upside down), a new set of LEDs will come on -- again usually separated by 120 degrees. I'll finish flipping the aircraft over, turn it to match the new LEDs, and flip it again. About 1.5 turns later (again, the aircraft is upside down), the LEDs will change again -- and so on. The third time or so they are usually LEDs separated by 180 degrees, but, at the end of the day, the calibration fails and I have no clue what's happening.
Any ideas? I'm quite lost here and any help is appreciated.