Hello from California
- Thread starter Chau09us
- Start date
I got nothing! The icons are gray meaning no connection between the drone and the phone
Follow the procedures in this post How To: Troubleshoot the Breeze and Request Help in the Forum. Be sure to note the sequences of both the Main LED/Power button and the Status LED in the left front arm.
Oh ok! Thank you Sir! Hope this info will solve the problems and I’ll let you know how it goes!
Breeze sequence of operations posted below is important if you want a trouble-free connection:
GO TO SETTINGS ON CELL PHONE
GO TO CONNECTIONS AND TURN AIRPLANE MODE ON
GO TO WI-FI AND TURN ON
GO TO BLUETOOTH AND TURN ON
TURN ON BREEZE DRONE
GO TO WIFI ON THE CELL PHONE AND WAIT FOR BREEZE NAME TO APPEAR
SELECT BREEZE FOR WI-FI CONNECTION
OPEN BREEZE CAM APP
SELECT TASKS
TURN ON THE CONTROLLER
ICON FOR CONTROLLER WILL FLASH YELLOW IN THE BREEZE CAM APP
SELECT CONTROLLER ICON WHICH ENABLES CONNECTION TO BLUETOOTH
WHILE IN BREEZE CAM APP SLIDE TO "EXPERIENCE NOW"
YOU ARE READY TO FLY!
Yuneec Breeze Connection Instructions
GO TO SETTINGS ON CELL PHONE
GO TO CONNECTIONS AND TURN AIRPLANE MODE ON
GO TO WI-FI AND TURN ON
GO TO BLUETOOTH AND TURN ON
TURN ON BREEZE DRONE
GO TO WIFI ON THE CELL PHONE AND WAIT FOR BREEZE NAME TO APPEAR
SELECT BREEZE FOR WI-FI CONNECTION
OPEN BREEZE CAM APP
SELECT TASKS
TURN ON THE CONTROLLER
ICON FOR CONTROLLER WILL FLASH YELLOW IN THE BREEZE CAM APP
SELECT CONTROLLER ICON WHICH ENABLES CONNECTION TO BLUETOOTH
WHILE IN BREEZE CAM APP SLIDE TO "EXPERIENCE NOW"
YOU ARE READY TO FLY!
Hi again!
I used 2 new batteries, and the status icons were lit except the OFM (optical flow module) icon error is on. The drone still couldn’t fly. So frustrated. Do you have any ideas?
Thanks for your help, but I still couldn’t fly the drone! Do I need a controller to fly the drone?
Another error came up: OFM error is on all the time, and that hold up the the take off of the drone. Have any ideas?
You do not ”need” the controller to fly the Breeze.
The Optical Flow Module (or sensor or camera) is the one in the very back on the bottom side of the Breeze. If you are using the Breeze indoors and getting this increase the amount of light in the area. If you are outdoors in strong sunlight on a light colored or reflective surface you can get this error. Also check that the glass cover is clean and free of dirt or smudges.
Hi again,
I still have problem with OFM after reading your post, the OFM icon is always red! I called customer services, but that number is no longer in service, and I emailed them but no reply! So frustrated!
There is no tech support in the US for now. I would suggest removing the bottom cover and check that the connector for the Optical Flow is properly seated in the M7 board beneath it, and no damage to the cable.
This is the OFM.
This is the M7 board.
The connector on the OFM’s cable fits into the one on the Center of the board that looks a bit like an inverse IC.
The OFM mounted to the M7 board.
Notice how the cable goes underneath the OFM to seat the connectors together.
This is the OFM.
This is the M7 board.
The connector on the OFM’s cable fits into the one on the Center of the board that looks a bit like an inverse IC.
The OFM mounted to the M7 board.
Notice how the cable goes underneath the OFM to seat the connectors together.
Thanks for your advices! I just had time to open the cover to adjust the cable a little bit today, and it worked! Wonder why? Maybe the cable is loose? I’ll test fly it this weekend for the first time and am very excited! Thanks
