Thank you to everyone that has helped, will update as this progresses.
I understand that the motors wont start unless all arm,
My thoughts with moving the escs around on the controller board was to confirm the current non arming escs would arm with a known good one plugged into that position on the controller thus eliminating any fault with the actual controller
again thank you one and all for your help, I really dont want to junk it if its just a couple of ESCs
I understand that the motors wont start unless all arm,
My thoughts with moving the escs around on the controller board was to confirm the current non arming escs would arm with a known good one plugged into that position on the controller thus eliminating any fault with the actual controller
again thank you one and all for your help, I really dont want to junk it if its just a couple of ESCs