Thanks for that RPR,
Maybe there are a lot like me and are very limited being able to post anything without help, I am hopeless without the help of my mate that guides me every bit of the way. He is fabulous for 72 yrs old and loves it. Now all go to my YouTube channel Yuneek ideaz and you will see the heat video or I will put a link in (hopefully) to a video site.
Now I don't want to bang on about this TOWER of mine and heat inside of the electronics of the H, but it all goes hand in hand if you don't ventilate it gets very hot and I doubt if people realize the temps that it reaches. A brief explanation of how this test was conducted and what was used.
Here is a video of 3 different SHELLS for the test
D) std shell with no compass module (as I don't have enough for all tests) but thermometer sensor in the same compartment with the copper shielding stuck back in place like standard H.
C) std shell, no module, the CARBON FIBER STAND made by Ricky Smith and sold on eBay, hole drilled in the shell where his video said to and the sensor inserted for temps, hole not plugged up and copper shielding with a hole for connector as if on the H.
B) std shell, no module, has Yuneec ideaz TOWER installed and no fan, white in colour with sensor put up inside where the module would sit and copper shielding with the flap cut and sealed as standard.
They are all as standard as can be to the instructions of the makers.
The photographer was me and it is as good as computer knowledge, which is terrible, but stick with it as the results are very significant.
RESULTS-- D) -- std ABS plastic shell 1.5 mm thick heats up quicker and also cools quicker. Characters of the materials and thickness.
C)-- CARBON FIBER STAND takes longer to start to get hot but goes well past all for temps and cools down slower. It is the character of the materials used.
B)-- White Yuneek ideaz TOWER was slowest to heat up and stayed the coolest by 6°C over D and
13 °C over the TOWER that is massive. This is not the fan model, I think that it creates a venturi effect or chimney effect and draws the air through the shell.
Then we go inside or the cooldown and this is where my mate lost most of his hair, I said I thought that the camera was Auto everything, it is but not Auto fix a disaster, but he salvaged some so that you will get the idea. This coupled with the short post and photos the other night gives you some idea of how much heat is generated, and don't forget that we don't have all the electronics running nor motors idling or taking off and flying or battery heat. The test thermometers were purchased from CORE ELECTRONICS Australia and are accurate to .05 of degree C.
After this, my next tests will be the FAN TOWER vs the Std TOWER .
NEXT, a video for Ah-G1 about the flight characteristics that the TOWER may vary on the H. Both my work H'S have both only had there gyros and accelerometers and gimbal s calibrated once and that was when I first purchased them in early 2017. To this day they fly smooth and stable in allconditions, which I will post.
The video s on my YouTube channel Uneek Ideaz. Now I will try to put the video link in.
https://video.com/327207928
If this does not work I will summon some help from my mate, but you can get it on my channel.
Johnno Hennessy,
Keep flying on the green side of the grass.