o rings

[NRRTRAINS]

dose any one know the size of the o rings used on the Q 500 motor shaft .
thank you

 

[Jafo]

I haven't measured them out but my guess is standard 1/4" id x 3/8" od

 

[NRRTRAINS]

I haven't measured them out but my guess is standard 1/4" id x 3/8" od

thank you
this is how to measure an o ring

 

[NRRTRAINS]

I haven't measured them out but my guess is standard 1/4" id x 3/8" od

when i get a chance i will measure them .

 

[Steve Carr]

Manufactured by DANCO Stock number 35870B, #90 O-ring 1/2" O.D x 1/4" I.D. x 1/8" H.

 

[NRRTRAINS]

Manufactured by DANCO Stock number 35870B, #90 O-ring 1/2" O.D x 1/4" I.D. x 1/8" H.

thank you

 

[Lost at sea since 1989]

Whats the Buna hardness? i'm guessing 90 as it's #90, 70 might be too soft.

Thanks

 

[Steve Carr]

Danco O-Ring 1/4 " Id. X 1/2 " Od. X 1/8 " Wall Nitrile Butadiene Rubber Polybag | eBay

 

[Lost at sea since 1989]

Cheers for that, Added to my shopping list. Never know when you will lose one of those little guys.

 

[NRRTRAINS]

Cheers for that, Added to my shopping list. Never know when you will lose one of those little guys.

hard to lose the o ring but i had one split and two get hard and frayed a little . lucky i always have a few sets on hand .