Yuneec Q500 with the CGo2 camera attached but removeable

[terryguindon57]

It has video but, I am getting warning light and sound beep beep beepbeepbeep , controlller wont move the camera up or down

 

[WTFDproject]

The camera and the gimbal are built into one unit for convenience, but they are two different things. You have a gimbal problem. Specifically, the Yaw encoder has a problem.
This would normally be a shop repair but it may be difficult to find a shop that can do the repair.
Did anything happen to the gimbal between the last time it worked and the first time it did not? Things like crash, long storage time, firmware updates, repairs, modifications or anything you can thing of?
You can also check that the connector marked "K" in the attached image is not loose or has wire damage.

 

[Peter b]

Is vertigo also gone?

 

[terryguindon57]

The camera and the gimbal are built into one unit for convenience, but they are two different things. You have a gimbal problem. Specifically, the Yaw encoder has a problem.
This would normally be a shop repair but it may be difficult to find a shop that can do the repair.
Did anything happen to the gimbal between the last time it worked and the first time it did not? Things like crash, long storage time, firmware updates, repairs, modifications or anything you can thing of?
You can also check that the connector marked "K" in the attached image is not loose or has wire damage.
View attachment 32323 yea I looked for damage on wires but there is nothing pluged in the socket for K

No damage

 

[WTFDproject]

Is vertigo also gone?

It looks that way. They went dark a couple of months ago.

 

[terryguindon57]

No damage

there is nothing plugged in the k socket no wires

 

[WTFDproject]

there is nothing plugged in the k socket no wires

Can you see under the gimbal board with a flashlight to see if a blue box is visible under the center of the board?

 

[terryguindon57]

No damage

ok led under the board is flashing red and 3 beeps I also put the camera in the steady grip on an angle while booting up and the

Can you see under the gimbal board with a flashlight to see if a blue box is visible under the center of the board?

yes

 

[WTFDproject]

So the blue box is there?

 

[WTFDproject]

There should be black wires coming out from the center with a white plug on the end. If you can find it and plug it back in, the gimbal may work again.