I was flying my hex, it was in a low hover, about 30 meters up and about 30 meters behind me... there was a light breeze. Out of no where, I got an error stating the drone was in 5 motor operation mode. I had never seen or heard of this happening so I didn't believe message. The drone was behind me when this happened, so when I turned around I could see one of the motors not spinning correctly. . I immediately flew the hex to safe location to land and thanks to the redundancy of a hex, I was able to pilot and land my hex with no issues. Here's the footage from that portion of the flight (embedded below) - https://youtu.be/C8duPXgiWbQ
Now I need to figure out what happened to determine if I did something in error or if the hardware failed. Does anyone have suggestions on how to trouble shoot a Typhoon and H using diagnostic tools and flight logs? Please share links to any tools and videos that you may have. Any and all suggestion are appreciated.
Now I need to figure out what happened to determine if I did something in error or if the hardware failed. Does anyone have suggestions on how to trouble shoot a Typhoon and H using diagnostic tools and flight logs? Please share links to any tools and videos that you may have. Any and all suggestion are appreciated.