That's true.Can't do that if it's not binding. And the lights should reset to "On" after a reboot.
Pretty much at this point.I think connecting to the computer is the only step that might show what is going on.
OK so I downloaded everything and updated. Firmware for st16 and typhoon and now the main led that is supposed to blink blue then yellow when ready to bind stays solid green mine turns solid green from when I turn it on and stays solid green, also the power button in drone will not power off I have to turn it off by pulling out batrI had one do this same thing recently. I had to do a complete firmware reinstall using the GUI.
Another thing to try is take the camera off completely and try and power the bird on (hold the power button down for 5-7 seconds). Once the bird powers on, install the camera.
Also what color is the led light on the front of your CGO-3+ (the camera) and is it flashing or solid in color? Flashing green indicates looking for connection, solid green is connection established, flashing yellow is no SD Card and looking for connection, solid yellow is no SD Card and connection established, flashing red is booting and flashing purple is updating. No light indicates a serious problem. (Sorry Steve I know you already liked what I had before)
Yes, this is the correct behavior. In Smart Flight Mode (please don't fly in smart mode until you've read the manual) the rear Aircraft Indicator Light will be solid green. Flip Switch S4 (top right corner) to the middle position on the st16, this will put you in Angle Flight Mode. Please refer to page 23 of the Typhoon H manual V1.2 located here: Downloads Typhoon HOK so I downloaded everything and updated. Firmware for st16 and typhoon and now the main led that is supposed to blink blue then yellow when ready to bind stays solid green mine turns solid green from when I turn it on and stays solid green, also the power button in drone will not power off I have to turn it off by pulling out batr
Can you tip the airframe forward several times (take the props off and tilt past the 35 degree angle)? This should cause the airframe to go into binding mode, you will see orange rapid flashing light on the rear of the airframe. Keep tipping until the light flashes. Feel free to stop after a minute of tipping. If the light starts flashing orange, grab the ST16, tap system settings, tap continue on the warning message.OK i t has been on for 5 min still solid green, and is not changing or blinking, how long does it take until it turns blue? I switched to angle mode
Is this a new or used airframe?Nothing us working....it is still solid green
So, you're good to go?OK so blue blinking doesn't matter BTW thank you for your help