- Joined
- Oct 31, 2016
- Messages
- 52
- Reaction score
- 9
- Age
- 58
Hello Everybody,
Even I think this is also related to the recent V3 update, I am opening a new discussion.
Since the V3 update
J2 never properly worked but until now I could fix the issue by calibrating the ST16.
Edit I did some more checks on the J2 and found out that it is not going to zero when totally released. This is explaining my drifts I experienced. Because I switched to Mode 3 the Elevator Channel moved to the left stick. So I cannot blame V3 for the drifts, it's seems to me a hardware problem on the left stick. I also noted that the left and right amplitude is slow and never going to -100 / +100
What do you think, sending in/back the ST16?
Thank you and cheers
Beat
Even I think this is also related to the recent V3 update, I am opening a new discussion.
Since the V3 update
- I cannot calibrate the J2 channel anymore. The corresponding gauge remains red independent what I am doing.
- The Hardware Monitor is not showing any reaction to any of my commands
Edit Funny, but it is working again after writing this post
J2 never properly worked but until now I could fix the issue by calibrating the ST16.
Edit I did some more checks on the J2 and found out that it is not going to zero when totally released. This is explaining my drifts I experienced. Because I switched to Mode 3 the Elevator Channel moved to the left stick. So I cannot blame V3 for the drifts, it's seems to me a hardware problem on the left stick. I also noted that the left and right amplitude is slow and never going to -100 / +100
What do you think, sending in/back the ST16?
Thank you and cheers
Beat
Last edited: