- Joined
- Jul 17, 2022
- Messages
- 51
- Reaction score
- 13
- Age
- 41
And what is the solution for it?This is is exactly how my Gimbal buzz would act, when I moved the camera down the buzz would go away.
And what is the solution for it?This is is exactly how my Gimbal buzz would act, when I moved the camera down the buzz would go away.
This is a repost from @Steve Carr, post #18 of this thread:And what is the solution for it?
Thats not solved the problemThis is a repost from @Steve Carr, post #18 of this thread:
C23 Gimbal Fix for Vibration
If you have a C23 camera that buzzes or vibrates this may fix the problem. Download the attached file. Unzip (uncompress) the file. The file name should be gimbal.yuneec Copy the file to a formatted sd card that you normally use in the camera. Install the card in the camera and watch the video...
yuneecpilots.com![]()
It fixed my problem which displayed the same symptoms yours does. Are you certain you performed the installation correctly? You might want to try it again just to be sure all the steps were in the proper order.Thats not solved the problem
I tried it three times, always done the fix. (File on card always renamed)It fixed my problem which displayed the same symptoms yours does. Are you certain you performed the installation correctly? You might want to try it again just to be sure all the steps were in the proper order.
Possible that the camera's factory calibration is gond and recalibration solve this problem?If the problem is not caused by dampers, unbalanced propellors or firmware, things get a lot more complicated. The next phase of investigation involves the communication path between the IMU and the gimbal board.
The path includes a short section of wire, some circuits on the camera board, several connectors of different size/type, two flexible conductor ribbons and of course, the IMU and Gimbal boards themselves.
It is at this point many people would begin to seriously consider sending this camera to a certified shop for repair.
Lots of possibilities remain. The calibration you mention is one. Defective magnets may be another, as well as defective encoders or the ribbons/connectors associated with those encoders. And then there would come questions about the motors and motor circuits. And probably other problems I have not even seen yet.Possible that the camera's factory calibration is gond and recalibration solve this problem?
IF you are good with soldering small parts, you can get the switches from places like eBay. The switch itself is a commonly available component..... I called the service, they confirmed that they are able to order parts. Possible to get these spare parts somewhere for me?
Of course. GPS works well, video image is clear, just the telemetry stand on 0.Do you have a picture from the camera?
Do you mean the telemetry isn't displayed at all or do you mean it is displayed but all the readings are zero?Everything is 0 while I fly.
Displayed but when I fly, nothing change.Do you mean the telemetry isn't displayed at all or do you mean it is displayed but all the readings are zero?
Can you post a picture of the screen to show us what you are seeing?
We use essential cookies to make this site work, and optional cookies to enhance your experience.