Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Need a diagnose, what cause this on videos?

It looks like the camera is bound to the controller but not the aircraft.
Turn off the ST16.
Put the gimbal lock on the camera. Turn on the H Plus.
After it boots up, turn the aircraft up side down and see if the motor lights all flash light green.
Turn on the ST16. When it finishes booting up, go to the bind menu and bind the aircraft.
You may have to press the refresh arrows several times before the aircraft is listed.
Checked, it was binded, but reconnected again.
 
  • Like
Reactions: Steve Carr
If it were my H Plus I would do a factory reset of the controller. I may be a glitch in the Flight Mode app. As part of the reset, the Flight Mode app must be reinstalled.
Or you could try to re-install the app without doing the reset.

 
Thanks Carr, honestly today a good guy bought my H Plus package. I hope next mintha, I can buy a brand new package of H3.

Finally I think I was unlucky with the H Plus.
 
  • Like
Reactions: Steve Carr

Members online

Forum statistics

Threads
20,954
Messages
241,586
Members
27,284
Latest member
csandoval