Dear fellow pilots, I'm just starting in the drone-world and found this to be the most active forum on Yuneec drones.
When the other day an h920 came to my place it was along with an st12 remote. This one now is starting into one screen where it welcomes me and schows some parameters but than starts flipping through settings. Sometimes I can access the systems settings bit through some influence except my fingers it starts to switch options making the device not useable. Just imagine the st12 beimg set to chinese, changing timezone, ... . Sometimes it comes up with messages like "please wait". Is this activity of the screen known and if yes what are the approved ways to correct this? The battery is looking charged. I assume there was never an update to the control. Thanks for your response.
When the other day an h920 came to my place it was along with an st12 remote. This one now is starting into one screen where it welcomes me and schows some parameters but than starts flipping through settings. Sometimes I can access the systems settings bit through some influence except my fingers it starts to switch options making the device not useable. Just imagine the st12 beimg set to chinese, changing timezone, ... . Sometimes it comes up with messages like "please wait". Is this activity of the screen known and if yes what are the approved ways to correct this? The battery is looking charged. I assume there was never an update to the control. Thanks for your response.
