Typhoon H New Siuation

KEITH KUHN · Aug 13, 2019

I had a new minor problem,which is now fixed I hope.
Last week I landed my
T-H . Not a perfect landing,but anyway I noticed it was beeping rapidly. Last flight of the
day. Did not think to much of it till i went to
Fly it a week later.
I fired it up and got the series of fast beeps again.
So no way was I going to fly it. I took it home and started investigating.
It seemed to have lost connection with my controller. I then did a factory reset on my controller, rebinded everything.
So it appears things are
back in order. I will know when I test fly it tomorrow. Anybody ever experience this
situation ?
Keith Kuhn

AH-1G · Aug 13, 2019

Page 22 in your owners manual, see if the LED STATUS info is there

PatR · Aug 13, 2019

Old issue originally discussed and resolved in 2016z

jannislh · Aug 14, 2019

Have you checked the hardware monitor of the ST16? It might only be the stick calibration. If you see an offset, this is very likely to be the case.

I had this issue quiet early when I got mine. It is a very fast beeping with a constant length. It does not stop but just keeps going until you arm the Typhoon. It does not really fit to you assumption that they lost connection but I strongly recommend to give it a try.

KEITH KUHN · Aug 14, 2019

AH-1G said:
Page 22 in your owners manual, see if the LED STATUS info is there

Thanks I Will Check that out.
Keith

KEITH KUHN · Aug 14, 2019

jannislh said:
Have you checked the hardware monitor of the ST16? It might only be the stick calibration. If you see an offset, this is very likely to be the case.

I had this issue quiet early when I got mine. It is a very fast beeping with a constant length. It does not stop but just keeps going until you arm the Typhoon. It does not really fit to you assumption that they lost connection but I strongly recommend to give it a try.

It's too late now because I already rest the controller.
But I will be keeping a close eye on things.
I did notice after the reset
My landing gear would not
retract but I fixed that (upside down trick)
I am going to do a complete recalibration and go for another test run tomorrow.
Thanks Keith

KEITH KUHN · Aug 14, 2019

AH-1G said:
Page 22 in your owners manual, see if the LED STATUS info is there

I will for sure chk page 22

KEITH KUHN · Aug 16, 2019

AH-1G said:
Page 22 in your owners manual, see if the LED STATUS info is there

I àm going to look
Again,the pages are not numbered

AH-1G · Aug 16, 2019

KEITH KUHN said:
I àm going to look
Again,the pages are not numbered

NorWiscPilot · Aug 16, 2019

KEITH KUHN said:
I àm going to look
Again,the pages are not numbered

Look again, Keith!

PatR · Aug 16, 2019

Just type “22” in the page number selection box at the top of the PDF window...

KEITH KUHN · Aug 17, 2019

PatR said:
Just type “22” in the page number selection box at the top of the PDF window...

I was looking at the paper manual that came in the
Box or carrying case.
It is a little white fold up
Sheet. I will check again.
But anyway I has 2 flights
after I did my controller
reset.On the second flight
Upon landing the rappid beeping returned.
So I will now look into
my joy sticks and anything
else I can check to try to remedy the rapid beeping.
Thanks
Keith Kuhn