I flew drone using E50, E90, and CGOET cameras in the morning, did the update in the afternoon, and now only issues with E90 camera.
After attempting update to the latest E90 software (updated on April 30, 2021). The controller fails to reconnect to the E90 camera during update. It is a weird issue, since when powering up the H520 w/E90 attached, I have a couple of seconds where I can control the camera gimble without video feed then E90 status light switches from white to red and I lose all connection to camera/gimble. Adding to the issue I had no issues after updating data pilot/controller and the E50 and CGO cameras. The issues seems to be a update software issue, just don't know if the issue is in controller or E90 software. I was told it may be caused by Update Pilot app on the controller and should uninstall/reinstall and try update again which I did and tried to run update but no luck.
After attempting update to the latest E90 software (updated on April 30, 2021). The controller fails to reconnect to the E90 camera during update. It is a weird issue, since when powering up the H520 w/E90 attached, I have a couple of seconds where I can control the camera gimble without video feed then E90 status light switches from white to red and I lose all connection to camera/gimble. Adding to the issue I had no issues after updating data pilot/controller and the E50 and CGO cameras. The issues seems to be a update software issue, just don't know if the issue is in controller or E90 software. I was told it may be caused by Update Pilot app on the controller and should uninstall/reinstall and try update again which I did and tried to run update but no luck.
Last edited by a moderator: