Did you get the rubber dampers reinstalled?I took BobW55's advice; removed the gimbal, replaced, and Voila! it works per normal - thanks Bob.
BTW: Are all 4 rubber isolation cups supposed to be attached at both ends?
If you are working on the ones that have the black plastic pin through them you can just cut the pin and toss it. Replace it after the damper is re-installed with 2 wire ties. Put one wire tie trough the center of the damper and then slide the other one on it. Cut the tail off the second one and trim the first to length. Keep it loose. Too tight and it will restrict movement of the rubber.The 2 pinned ones never came loose.
I think I succeeded in getting one of the dampers which detached at the fixed (non-floating) end reattached - but the other one refuses to reattach at the fixed end.
Is there some procedure/tool for attaching those things?
Thanks