- Joined
- Jul 17, 2022
- Messages
- 47
- Reaction score
- 13
- Age
- 40
How can I find a long shaft for it what able to lock the prop?I agree the probable cause is vibration from props. Generally H props are well balanced right out of the box. But I have found some that needed balanced.
I use short pieces of Scotch tape near the center of the prop on the underside. I have tried different balancing jigs but I find a tall water glass with a long shaft to be the most sensitive. In the video below I used a Q500 prop balancer. It fits perfectly inside the H props.
Can you tell ne who can fix this? Should I send it to Yuneec Gmbh or somebody else can repair it? And of course how much does it cost?The gimbal buzz is a preliminary symptom of a bad magnet in the future. The camera should be repaired. Of course, a gimbal kit is a must-have too.
Where can I find this fix and how can I install it?Hey I recognize that! It looks just like the effect caused by gimbal buzz! A while back, a few (maybe several) of us were experiencing a very bad gimbal vibration after a firmware update. Back before I fixed the gimbal buzz issue I would get video results that looked just like that. That condition is correctible with a fix you can install to the camera. @Steve Carr will remember this and direct you to the fix -if gimbal vibration is the problem -which it sure looks like to me. So If changing the props doesn't work, start listening for a buzz and check the gimbal with your hand for gimbal vibrations.
At least say us from where you are. If you're from the USA, ask @Yuneec Skins .Can you tell me who can fix this? Should I send it to Yuneec Gmbh or somebody else can repair it? And of course how much does it cost?
No idea how to help you. Try Yuneec Europe. Here it has some positive feedback.I'm from Europe
This is is exactly how my Gimbal buzz would act, when I moved the camera down the buzz would go away.
Made this video today, seems when the camera looks perfectly horizontal, than do the waving. When I look down, it's disappear.