Hi Everyone,
Short version:
1) Hex lost a prop and fell from 125 ft... 5 other rotors helped from complete disaster (still pretty hard fall)
2) Took home and repaired with all my box full of parts
3) During repair, I DID remove my Intel RealSense
4) Grabbed my backup CG03+ went behind house, fired up ST16... and H. Went into system settings "unchecked" Intel RealSense and binded the new CG03+
5) Restarted everything and the main LED quickly flashes blue on startup for about 5 seconds then goes to purple to show i'm in Angle mode with GPS locked.
Now the fun starts. unfamiliar with this, I do a compass calibration and restart. (Still flashing blue LED at startup)... once turns to purple, I decided to slowly bring it up 7 feet in the air and see what happens... it was good for maybe 3 seconds and then started drifting and rocking (slowly) as well as LED was blinking red/orange sporadically... landed immediately.
I thought about re-binding the H, so I was able to put it in Bind mode and it Binded to the ST16 controller, but that didn't fix anything.=
NOTE - I still consider myself a "Beginner" when it comes to the software part and "binding", "telemetry", "clearing data". I have 3 shoots lined up tomorrow and would love to not have to cancel on them!
Here is picture of H flashing blue on startup and then also flashing blue anytime I go into "system settings"
(or see video in zip file)
HELP PLEASE
Short version:
1) Hex lost a prop and fell from 125 ft... 5 other rotors helped from complete disaster (still pretty hard fall)
2) Took home and repaired with all my box full of parts
3) During repair, I DID remove my Intel RealSense
4) Grabbed my backup CG03+ went behind house, fired up ST16... and H. Went into system settings "unchecked" Intel RealSense and binded the new CG03+
5) Restarted everything and the main LED quickly flashes blue on startup for about 5 seconds then goes to purple to show i'm in Angle mode with GPS locked.
Now the fun starts. unfamiliar with this, I do a compass calibration and restart. (Still flashing blue LED at startup)... once turns to purple, I decided to slowly bring it up 7 feet in the air and see what happens... it was good for maybe 3 seconds and then started drifting and rocking (slowly) as well as LED was blinking red/orange sporadically... landed immediately.
I thought about re-binding the H, so I was able to put it in Bind mode and it Binded to the ST16 controller, but that didn't fix anything.=
NOTE - I still consider myself a "Beginner" when it comes to the software part and "binding", "telemetry", "clearing data". I have 3 shoots lined up tomorrow and would love to not have to cancel on them!
Here is picture of H flashing blue on startup and then also flashing blue anytime I go into "system settings"
(or see video in zip file)
HELP PLEASE